Project Quality Supervisor Coating

RESPONSABILITATI

-Read and understand the Project Specification, applicable Codes and Standards, Procedures and inspection Test Plan.
-Calibration of inspection and test instruments, using coatings inspection and test instruments.
-Enforcement and verification of work performed in accordance with specification, manufacturer recommendations and coating procedure.
-Witness applicator qualification or trade test and paint system qualification.
-Measure ambient conditions, surface temperature and air quality requirements.
-Inspect type of blasting equipment and tools to be used.
-Inspect type and size of blasting media.
-Test indication of oil or water in compressed air.
-Test analysis of water-soluble ionic contamination of blasting media.
-Inspect pre-cleaning, solvent cleaning of surface, mechanical surface preparation during pre-fabrication and onsite portable centrifugal blasting, open air blast, vacuum blast cleaning, hand and power tool cleaning.
-Measure compressed air pressure.
- Inspect degree of cleanliness required.
-Measure surface profile of blast cleaned surface.
-Assess surface cleanliness of blast cleaned surface.
-Assess surface cleanliness soluble salt contamination on blast cleaned surface.
-Inspect coating material storage conditions.
-Inspect type of coating material to be used.
-Monitor thinning, mixing, induction time and pot life.
-Inspect type of coating application equipment, Thermal Sprayed Aluminum, Passive Fire Protection, self leveling compounds, Anti-skid deck coatings, Coated Hot dip, Galvanizing, Insulation and its acceptance.
-Monitor application method, type and pattern.
-Measure wet film thickness by notch gages.
-Non-destructive measurement of dry film thickness of non-magnetic coatings/non-conductive coatings applied to ferrous surface.
-Monitor re-coating and final curing schedules.
-Test MEK resistance of Inorganic Rich Primers by solvent rub.
-Measure the adhesion of coatings applied.
-Test pull-off strength of coatings applied.
-Test discontinuity (holidays or pinholes) of coatings and linings.
-Defects affecting performance of the applied coatings.
-Inspection of defects on coated surface.
-Acceptable and unacceptable defects.
-Identification of defects and implementation of repair procedure.
-Protective coating inspection standards for field and shop applications.
-To stop non-conforming work and inform the production supervisor of required corrective rework.
-Documentation of the daily inspection activities and others as per the project requirement.

CERINTE

DESCRIEREA FIRMEI

Firma de recrutare si plasare de forta de munca in domeniul ingineriei, specialitatea Oil&Gas.